- 5318 Victory Drive
Indianapolis, IN 46203 - (800) 622-4824
- www.haggard-stocking.com
29.5mm Diameter Extra Length Drill, 2 flutes, HSS, Steam Oxide Coated, Morse taper Shank, 130° Point, Right Hand Cut
- Item Code: 527-29.500
- Brand: Guhring
- Unit Size: 1
Description
A Morse Taper Shank drill incorporates a standardized taper shank design that is used in tapered drill chucks. The Morse Taper was invented by Stephen A. Morse (also the inventor of the twist drill) in the mid-1860s. Morse Tapers come in eight sizes identified by number between 0 and 7. Often this is abbreviated as MT followed by a digit, for example a Morse taper number 4 would be MT4. The MT2 taper is the size most often found in drill presses up to 1/2'' capacity.
Features
Back To Top- Reduce -- and even eliminate -- the need for chip clearing peck cycles
- Increased feed rates over standard high speed steel drill flute designs
- Chip evacuation is improved for better finished hole and part quality
- Reduce cycle times and improve manufacturing efficiency
- Hundreds of stocked standard sizes in inventory
Tech Specs
Back To Top| Flute Length (mm) | 385 |
|---|---|
| Length of Cut (mm) | 340.75 |
| Overall Length (mm) | 580 |
| Brand | Guhring |
| Decimal Diameter | 1.1614" |
| Coating/Finish | Steam Oxide |
| Drilling Depth | Extra Length |
| Cutting Direction | Right Hand |
| Metric Diameter | 29.50 mm |
| Point Angle | 130° |
| Shank Type | 3MT |
| Number of Flutes | 2 |
| Material | High Speed Steel |
| Series | 527 |