• 5318 Victory Drive
    Indianapolis, IN 46203
  • (800) 622-4824
  • www.haggard-stocking.com

14mm Diameter Bushing Length Drill, 2 flutes, HSS, Nitrided Lands, Morse taper Shank, 130° Point, Right Hand Cut

  • Item Code: 551-14.000
  • Brand: Guhring
  • Unit Size: 1

Description

A Morse Taper Shank drill incorporates a standardized taper shank design that is used in tapered drill chucks. The Morse Taper was invented by Stephen A. Morse (also the inventor of the twist drill) in the mid-1860s. Morse Tapers come in eight sizes identified by number between 0 and 7. Often this is abbreviated as MT followed by a digit, for example a Morse taper number 4 would be MT4. The MT2 taper is the size most often found in drill presses up to 1/2'' capacity.

Features Tech Specs

Features

Back To Top
    • Reduce -- and even eliminate -- the need for chip clearing peck cycles
    • Increased feed rates over standard high speed steel drill flute designs
    • Chip evacuation is improved for better finished hole and part quality
    • Reduce cycle times and improve manufacturing efficiency
    • Hundreds of stocked standard sizes in inventory

Tech Specs

Back To Top
Length of Cut (mm) 121
Brand Guhring
Shank Type 1MT
Metric Diameter 14.00 mm
Flute Length (mm) 142
Overall Length (mm) 223
Coating/Finish Nitrided
Number of Flutes 2
Point Angle 130°
Material High Speed Steel
Cutting Direction Right Hand
Decimal Diameter 0.5512"
Drilling Depth Bushing Length
Series 551