• 5318 Victory Drive
    Indianapolis, IN 46203
  • (800) 622-4824
  • www.haggard-stocking.com

9/16 Inch Diameter, Bushing Length Drill, 2 flutes, HSS, Nitrided Lands, Morse taper Shank, 130° Point, Right Hand Cut

  • Item Code: 551-14.290
  • Brand: Guhring
  • Unit Size: 1

Description

A Morse Taper Shank drill incorporates a standardized taper shank design that is used in tapered drill chucks. The Morse Taper was invented by Stephen A. Morse (also the inventor of the twist drill) in the mid-1860s. Morse Tapers come in eight sizes identified by number between 0 and 7. Often this is abbreviated as MT followed by a digit, for example a Morse taper number 4 would be MT4. The MT2 taper is the size most often found in drill presses up to 1/2'' capacity.

Features Tech Specs

Features

Back To Top
    • Reduce -- and even eliminate -- the need for chip clearing peck cycles
    • Increased feed rates over standard high speed steel drill flute designs
    • Chip evacuation is improved for better finished hole and part quality
    • Reduce cycle times and improve manufacturing efficiency
    • Hundreds of stocked standard sizes in inventory

Tech Specs

Back To Top
Length of Cut (mm) 125.565
Cutting Direction Right Hand
Drilling Depth Bushing Length
Material High Speed Steel
Number of Flutes 2
Overall Length (mm) 245
Shank Type 2MT
Series 551
Decimal Diameter 0.5626"
Flute Length (mm) 147
Fractional Diameter 9/16"
Metric Diameter 14.29 mm
Brand Guhring
Coating/Finish Nitrided
Point Angle 130°